How To Make A Sawhorse

Angle each 30-inch leg under the lip of the I-beam and drill four pilot holes into the I-beam. Drive four deck screws into each leg to secure them to the sawhorse.

How To Build Stackable Sawhorses

A pair of sawhorses can also be used to make a makeshift work table or scaffold.

How to make a sawhorse. Hold the angled end against the spreader brace and scribe the other end where it intersects the top board then cut this mark. HttpsclikccySkDR and get a special starter pack Available on. A sawhorse gives the board youre sawing the support and elevation you need to make a clean cut.

Make two pencil marks on the 2x4 piece where the edges of the side pieces reach. Just use the two sawhorses as the legs and place a sheet of plywood over it. Cut another board about 18 inches 46cm long with a 45 degree angle on one end as the diagonal brace.

Heres the build article with more details and a free SketchUp model with all of the dimensionshttpsibuilditcaprojectsmake-folding-saw-horsesIve mad. Fasten the leg to the board with a screw. Flip the horse back over on its top board and prop it in place or have someone hold it.

We used 2-12 inch wood screws but any length will work so long as the screw can pass through the board and at least one inch into the leg. Install Raid for Free IOS. Create the end pieces for the 47-inch sawhorse the same way you did for the 49-inch sawhorse.

Take a piece of 2x4 and hold it over the ends of two side pieces. Do the same process for the other end of the sawhorse. Hold the leg flush against bottom of your top board when drilling.

Sawhorse Plans Diy Family Handyman