How To Install A Hot Water Heater

Place the new water heater in a drain pan. Begin the gas water heater installation by draining the old water heater tank.

Hot Water Heater Install Doityourself Com Community Forums

3 turn on a nearby hot water faucet until water comes out.

How to install a hot water heater. Label the wires with tape to mark. Many water heater companies such as AO Smith will only approve a warranty claim if the water heater was installed by a qualified professional. Presently cut an opening between the studs and connect the unit to the wall as per the guidance control.

Apply soldering paste to both the pipe and fittings and assemble. Problems installing a water heater will at a minimum cause some frustration but can also become dangerous. Apply plumbers tape white to the hot and cold heat trap nipple threads.

Installation involves wrapping the threads with plumbers pipe-seal tape then threading the nipples into the openings and tightening them with channel-lock pliers or a pipe wrench. Attach the flexible hoses to the hot and cold water nipples. You can install it on a wall.

With the water and gas off drain the water heater. If your water heater uses electricity plug it in to the wall If your water heater is gas you will need to hook up a gas supply line from the stub at the wall to the new water heater. Attach a garden hose to the drain valve at the bottom of the tank route it to a floor drain and open the drain valve.

Use a hand air pump to increase pressure or depress the valve to lower it. Then follow these four steps to fill the tank. Reading these warranties before purchasing the water heater will help you avoid.

The initial step is to set the heater into the divider between studs. Turn off the water supply to the water heater. Open the valve so that the handle is in the same direction as the line.

And 4 inspect all the joints and fittings for water leaks. Check the water heaters electrical wiring with a voltage detector to make sure that no power is reaching the unit. 2 turn the water back on at the main shutoff and open the cold water valve to the water heater leave it open.

Heat the fitting and then solder the connection. Turn OFF the electricity to the water heater at the electrical panel. 1 Close the drain valve.

Electric water heater installation requires that the expansion tank pressure match the main water pressure to work effectively. Install the discharge pipe to the TP relief valve. Delivery of a new hot water heater to your home proper disconnection of the old unit installation of the new unit and proper testing to ensure the new hot water heater is installed correctly.

Attach galvanized plastic-lined nipples to the cold water inlet and hot water outlet openings on the top of the water heater. Turn on the nearest hot water faucet and allow it to run until the water runs cool. Presently check the temperature rise and the ideal heated water temperature short of the approaching groundwater temperature.

Also turn the control valve to off on the water heater. To allow air into the hot water lines and speed up the draining process go to the highest faucet in the house and turn on the hot side only on single-handle faucets push. Our installation process consists of several basic tasks.

Then turn off the gas supply valve to the water heater. Step 1 - Remove the Old Water Heater.

How To Install Gas Water Heater