How To Make Wooden Steps

The rise of each step is determined by the height of the landing from the. How to build some simple and cheap wooden steps.

How To Build Stairs Stairs Design Plans

Now find the height of each step by dividing the value of total height by 7.

How to make wooden steps. The result number of that division is the number of required risers. The typical rise per step is about 658 inches 1720 cm but youll probably use a slightly different height for the actual rise. The Servary Guide To Stairs Diy Stairs Diy Staircase Stair Remodel Tack the skirts and screw the skirts to the top landing surface.

Next level the ground and build up low spots with fill dirt so the area slopes away from the house. Use corrosion resistant screws and nails to assemble the steps. Fit the treated 2 x 4 into the notch and press it flush to the wall.

How to Build Stairs. For example if the height is 55 inches divide this measurement by 7 the ideal height in inches for each step. For example divide 35 inches by a 7 inch riser to get 5 steps.

Step 1 Place the three step blanks on a work surface. You will get 12 steps. Start by measuring the width of the opening then cut a treated 2x4 to length to attach to the side of the house as an anchor for the stringers.

Trace along both inside edges of the framing square. Determine the location of your bottom step. Clamp the stair gauges to the carpenter s square.

Use this measurement to determine the number and height of the risers. Determine Number of Risers From the previous step use the measurement and divide it by 7 inches minimum. First steps can be tricky and people can fall even if you do everything right.

Set a long level on top of the decking and measure the height at the point where you want your steps to end. Make sure all of the step risers are the same height and all the step treads the same width to avoid a tripping hazard. Next mark the steps on your stringers cut out the steps with a saw and attach the stringers to your porch.

Ok your porch is 2-3 feet off the ground and jumping is becoming a drag. Create the curve for the rounded steps on the flexible curve ruler. For big stairs long runs or other difficult situations hire someone.

If you want to build porch steps measure from the top of the porch to the ground then take the total height and divide it by the riser which is usually between 6 and 8 inches. So this is meant to be simple plans for simple wooden steps. Building outdoor wooden steps requires a clear level area.

If you make them yourself you can match the wood and finish of your existing woodwork. The 7 inch number represents the approximate step height which sometimes is determined or regulated by the local building code. How to Build Wooden Deck Stairs When building stairs or steps for a deck.

Remember to take 3 off the length of the anchor. For example if your total rise is 95 inches 240 cm divide it by 7 inches 18 cm to get 1353. Divide the total rise by the typical rise per step.

Position one stringer against the wall and have a helper hold it in place. Start by removing shrubs and plants from the spot where the steps will be located which could be alongside the house a porch or a deck. Use a masonry bit to drill through the 2 x 4 and into the concrete floor then attach the 2 x 4 to the floor with concrete nails.

Slide the square down the wood to the next step location lining the edge of it up with where your last scribe line left off and continue with. Then wedge the 2 x 4 between the bottom notches and secure it with wood screws. How to make wooden stairs.

This will give you the total number of steps on your stairs.

How To Build Outdoor Wood Steps How Tos Diy